IC NE 555 timer:
The NE555 is an integrated circuit that capable of producing accurate timing pulses. This IC is used as a multivibrater. By using this IC we can construct two types of multivibrater, monostable and astable. The monostable multivibrater produces a single pulse when a triggering pulse is applied to its triggering input. The astable multivibrater produces a train of pulses depending on the Resister-Capacitor combination wired around it.
With a monostable operation, the time delay is controlled by one external resistor and one capacitor connected between Vcc-Discharge (R), and Threshold-Ground (C). With an astable operation, the frequency and pulse width are produced by two external resistors and one capacitor connected between Vcc-Discharge (R), Discharge-Threshold (R), and Threshold-Ground (C).
![Figure (J). Block diagram of IC NE 555 Figure (J). Block diagram of IC NE 555](https://studentprojects.in/wp-content/uploads/2008/11/blockdiagram555.jpg)
74154 4-16 line decoder/demultiplexer:
IC 74154 is a 4-16 line decoder, it takes the 4 line BCD input and selects respective output one among the 16 output lines. It is active low output IC so when any output line is selected it is indicated by active low signal, rest of the output lines will remain active high. This 4-line-to-16-line decoder utilizes TTL circuitry to decode four binary-coded inputs into one of sixteen mutually exclusive outputs when both the strobe inputs, G1 and G2, are low. The demultiplexing function is performed by using the 4 input lines to address the output line, passing data from one of the strobe inputs with the other strobe input low. When either strobe input is high, all outputs are high. These demultiplexer are ideally suited for implementing high-performance memory decoders.
![Figure (G). IC 74154 4-16 line decoder Figure (G). IC 74154 4-16 line decoder](https://studentprojects.in/wp-content/uploads/2008/11/blockdiagram74154.jpg)
All inputs are buffered and input clamping diodes are provided to minimize transmission-line effects and thereby simplify system design.
Truth Table:
![Truth Table of IC 74154 Truth Table of IC 74154](https://studentprojects.in/wp-content/uploads/2008/11/truth74154.jpg)
74126 Tri – State Buffer
This IC is a tri state buffer contains four independent gates each of which performs a non-inverting buffer function. The outputs have the 3-STATE feature. When control signal is at high state, the outputs are nothing but the data present at its input terminals. When control signal is at low state, the outputs are held at high impedance state. So no output will be available at the output terminal.
![Figure H. IC 74126 Figure H. IC 74126](https://studentprojects.in/wp-content/uploads/2008/11/blockdiagram74126.jpg)
IC 7474 D-flip-flop
IC 7474 is a conventional D-flip-flop IC. This IC consists of two D flip-flops. These flip-flops are used to latch the data that present at its input terminal. Each flip-flop has one data, one clock, one clear, one preset input terminals.
![Single D-flip-flop Single D-flip-flop](https://studentprojects.in/wp-content/uploads/2008/11/blockdiagram7474.jpg)
Seven Segment Decoder:
The DM74LS47 accepts four lines of BCD (8421) input data, generates their complements internally and decodes the data with seven AND/OR gates having open-collector outputs to drive indicator segments directly. Each segment output is guaranteed to sink 24mA in the ON (LOW) state and withstand 15V in the OFF (HIGH) state with a maximum leakage current of 250 mA. Auxiliary inputs provided blanking, lamp test and cascadable zero-suppression functions.
![Figure I. IC 7447 BCD - seven segment decoder Figure I. IC 7447 BCD - seven segment decoder](https://studentprojects.in/wp-content/uploads/2008/11/blockdiagram7447.jpg)
hello!
i want the fully detail of this project like circuit diagram, component,discription,blockdiagram,equilanant ICs list that used in this project and coding.
please……
i m very thankful to you…
Great project renjith!!!
pls give circuit diagram device control through telephone. using micro controller IC. IC 89S52
pls i would like see the circuit diagram and implementation of the project
it is too good but i want some more inf
sir,m doin this project but by usin mc-8951…can u mail me details if u hav any?
sir i m an engineering student..
i work on this project in my final sem..
but because of some errors in my program my project is not run..
will u please send me a program..
sir,my submission will be start from 14 april…
so,plz send me a prog. as fast as possible…
plz sir,,,,,
Hy –
i want the fully detail of this project like circuit diagram, component,discription,blockdiagram,equilanant ICs list that used in this project and coding.
please……
i m very thankful to you…
Sir I need the circuit and components urgently I cannot find it anywhere.please help.
Hi,
Doing MSC project and would
highly appreciate if you can send me the fully detail of this project
like circuit diagram, components,description,block diagram,equivalent
ICs list ,microproccesor used.
Kind request
Regards,
Bernard
I have visited your blog before. The more I visit, the more I keep coming back! ;-P
sir,i am doing a project on this
i need a fully detail on this project like circuit diagram, components,description,block diagram,equivalent ICs list that used in this project and coding., used.
hi, i need the coding 4 this project. pls send me the coding(program)……
Smart Idea ranjith !
Me too working on the same concept, can do me a favour? If you can send me its block and Circuit Diagram please.
Thanx,
looking forward for ur positive reply 😉
sir,
very very thanks
i need a fully detail on this project like circuit diagram, components,description,block diagram,equivalent ICs list that used in this project and coding., microcontrller programming for controlling devices
this is agood project.
i need this project.
hi…
how to make code on PIC simulator for automated appliances
controller using PIC16F84A
please answer my question.
how to make code on PIC simulator for automated appliances
controller using PIC16F84A
this is a very important project….i need your answer….
this is really good project please give the detail information and circuit diagram
Sir, please forward me the details of this project like circuit diagram and
further description of this project !
need a fully detail on this project like circuit diagram, components,description,block diagram,equivalent ICs list that used in this project and coding..its humble request
sir,
can u please provide the complete information reguarding this project. Iwould be pleased if u do so…..
sir
i want to know fully detail of ‘dtmf based remote control using telephone ‘project like name and description,equevalent ic’s list that used in this project and coding..its humble request
i am student of ece final year,i need the details of this project for minor project.pls mail me all data of this…
hi ranjith!!!!
really a must appreciable one!!it would create immense pleasure if i could get a clear idea of how u applying the concept..
thanking you!!
bye!!!
Sir,
I want to be a full information about this project,
How to make a circuit and other things which can clear my doubts.
Thank You !
Sir,
I want to be a full information about this project,
How to make a circuit and other things which can clear my doubts.
Thank You
sir i want the circuit diagram of this …. in order to learn it practically
how it works…
i will be very much thankful to u … if u forward me the circuit diagram and
further details on this topic….
hello!
i want the fully detail of this project like circuit diagram, component,discription,blockdiagram,equilanant ICs list that used in this project and coding.
please……
hello
i found the project extremely innovative and interesting..i am wanting to make
it for my college technical festival..it is just a month far from now..if you
could just help me out i would be very grateful..i just need a few tips and the
component list..ilive in india so advice me the appropriate devices..
i am extremely grateful to you..i would appreciate if you could reply as soon as
possible..
thank you
could you please mail me all details including circuit diagram.. i need it
please mail me the program and detail about project
Hi
I am doing a similar project.
Could you please mail me the design details including circuit diagrams
and snapshots(if available) of this project.
It would be of great help.
thanks
Wow….
I am interested to do this project for my home’s devices control so plz send me all details of this project with list all require components, circuit diagram, and details about how to do it…
I hope that you will send me all this detail earlier…
Thank you so much…
i want to make it, so plz send me all detail regarding this project.
I read all about this project and i like it so much, so can u plz send me all the details like circuit diagram, component used ,description and block diagram.Hoping for your reply as early as possible.
Thank you
hi i am using 89c2051 in this project which controls 8 relays and the controlling keys are 11,21—-81 to turn 1-8 relays and 10-80 to turn off.pls send me the program code for this as soon as possible.
sir,
can u send me the project to my mail id ovsureshbabu@gmail.com plz
hi, really very interesting project,please can you send me the full details of it,even every small detail,to work in one shot, my mail is vipinbali2010@gmail.com
thanks
vipin
plz send me all detail regarding this project.